T11
Using the T11 Without Fine
Height Adjuster
In portable use the knurled nut (2) should be
wound to the top of the stud and hand tighten
against the hex cap. The base of the knurled
nut (4) should be aligned with the forks (3) in
the router casting.
In normal plunge mode, ensure
the base of the knurled nut is
aligned correctly with the forks
of the lower motor housing.
This will enable the cutter to
retract into the base safely.
Fitting and Removing T11
Dust Extractor Spout
The dust extraction spout consists of a main
section (1) with underside clip (7), an insert
cover (2) and top clip (5) with screw (6).
I Check underside clip (7) is fitted into main
section. Slide the insert cover (2) onto the
main section if required (1) and click into
place.
I Clip into the base by pushing down the dust
extraction spout (1) until clips engage in the
recess.
I Connect a dust extractor hose to the dust
extraction spout (1).
I Loosen the screw in the top of the router and
fit the top clip (5) as shown using screw (6).
I To remove dust extraction spout, push spout
(1) to side and pivot out.
For more permanent fixing, fit nuts (4) into main
body, place spout into base of router and secure
with two screws (3).
Fitting Dust
Extractor Spout
Whenever possible use the dust
extraction spout with a suitable
extractor when routing.
To Next Page
Loading...
Need help?
General
