Wireless Settings
This section allows users to configure all wireless settings of the router. Allows you to set
the wireless configuration items.
Wireless Module: You can enable or disable wireless function.
Network ID (SSID): Network ID is used for identifying the Wireless LAN (WLAN). Client
stations can roam freely over this device and other Access Points that have the same
Network ID. (The factory default setting is “default”)
SSID Broadcast: The router will broadcast beacons that have some information,
including SSID so that wireless clients can know how many AP devices by scanning the
network. Therefore, if this setting is configured as “Disable”, the wireless clients can not
find the device from beacons.
Channel: The radio channel number. The permissible channels depend on the Regulatory
Domain. The factory default setting is as follow: channel 1~11 for North America.
(Channel 1~13 for European (ETSI); channel1~ 14 for Japan).
Wireless Mode: Choose “B/G mixed”, “B only”, “G only”, “N only”, “G/N mixed” or
“B/G/N mixed”. The factory default setting is “B/G/N mixed”.
Authentication mode: You may select one of authentication to secure your wireless
network: Open Shared, Auto, WPA-PSK, WPA, WPA2-PSK, WPA2, WPA-PSK/WPA2-PSK, or
To Next Page
Loading...
Need help?
General
