© 2018 Triacta Power Solutions LP All Rights Reserved
USB 2.0 (For Future use)
1 x Host, 1 x OTG
-40 to 70
o
C (No LCD display below -20
o
C)
Indoor environment, NEMA 250 Type II
Use the unit only in accordance with the electrical power rating.
The unit is only to be installed by a qualified electrician
Initial installation of the unit must be inspected by the local electrical Inspection Authority
Install the unit in compliance with the following local and national electrical codes:
x Canada: Canadian Electrical Code, Part I, CSA C22.1
x United States: National Fire Protection Association (NFPA) 70; US National
Electrical Code
x Elsewhere: International Electro-technical Commission (IEC) 364, Part 1-7
Ensure that the unit is properly earthed
Provide a disconnect device to disconnect the meter from each supply source. Place these
devices in close proximity to the equipment and within easy reach of the operator.
If the equipment is installed or used in a manner other than that specified in this document, it
may void your warranty or impair the protection of the equipment