© 2018 Triacta Power Solutions LP All Rights Reserved
MAINTENANCE
Do not perform any operation or maintenance procedures that are not described in this
product documentation. No preventive maintenance is required on any of the equipment.
Visually inspect the equipment yearly and ensure it is free of dust or other particles. If
necessary, wipe with a clean cloth. Individual components are not user-serviceable and must
be returned to Triacta Power for repair.
Fuse Replacement
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow
safe electrical work practices. See NFPA 70E.
• Turn off all power supplying this equipment before working on or
inside equipment.
• Always use a properly rated voltage sensing device to confirm the
power is off.
• Replace all devices, doors and covers before turning on power to
this equipment.
Failure to follow these instructions will result in death or serious
injury
1. Turn off all sources of power before attempting to replace
the fuse. Always use a properly rated voltage sensing
device to confirm the power is off.
2. Remove the outer cover from the unit.
3. Locate fuse F1 on the Triacta GATEWAY Voltage Module
as shown in Figure 4.
4. Replace fuse F1 with a fuse that meets the specifications
listed in Table 1.
To Next Page
Loading...