TRIATEK UVM-1000 User Manual

1
UVM-1000
Universal Valve Module
LIT-12013155
September 2020
Installation Guide
This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when this equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area may cause harmful interference, in which case users will be required to correct the interference at their own expense.
Canada
This Class (A) digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la Classe (A) respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
IMPORTANT: The UVM-1000 Universal Valve Module must be wired to 24 VAC only. Wiring the unit to 110 VAC will cause serious
damange and void the warranty.
Risk of Property Damage.
Ensure that the power source conforms to the requirements of the equipment. Failure to use a correct power source may result in
permanent damage to the equipment.
Risque de dégâts matériels.
S’assurer que la source d’alimentation électrique est conforme aux spécications de l’équipement. L’utilisation d’une source
d’alimentation électrique inappropriée risque d’endommager irrémédiablement l’équipement.
North American Emissions Compliance
United States

TRIATEK UVM-1000 Specifications

General

Brand	TRIATEK
Model	UVM-1000
Category	Control Unit
Language	English

Summary

Setup Overview

Introduction and Operation

Introduction

Explains the Universal Valve Module's purpose and interoperability with third-party controllers.

Overview of Operation

Explains the basic functionality and signal flow of the UVM for valve control and CFM output.

Installation and System Integration

Installation and Setup

Details the physical wiring and electrical connections for the UVM, actuator, and power supply.

UVM to FMS165X-S-0-1 Start Up

Guide for integrating the UVM with a specific FMS controller, covering DIP switches and input/output configurations.

UVM Configuration and Calibration

UVM Configuration Tool

Introduces the Triatek configuration tool for setting up the UVM, including installation and interface overview.

User Settings Tab

Main tab for configuring UVM settings, operational modes, and controller states.

CFM Table Tab

Process for entering and calibrating valve flow curves and feedback sensor data.

Dynamic Values Tab

Accessing live input/output values for monitoring and debugging UVM performance.

Factory Settings Tab

Details internal configuration settings for analog inputs/outputs and factory calibration.