The IP Settings window is used to specify unique IP addresses and
subnet masks used by the Link 1 and Link 2 sockets on the main and
sub units. This provides additional functionality to avoid IP address
conflicts.
1. Select the Switch radio button.
2. Specify unique IP addresses and subnet mask details for the
main and subunits in the corresponding fields.
3. Press the OK button.
Note:
The AUX 1, AUX 2 and associated IP Address and Subnet mask
fields are used in connection with the IP output module.
Remaining steps are valid for all multi-unit installations.
The 512 IP addresses used by the headend(s) must not conflict with
any of the IP addresses used either within the network or for services.
1. Enter the first of the 512 IP addresses used for internal
purposes in the Start field.
2. Press the OK button when all changes have been made.
To Next Page
Loading...
