triOS TriBox3 - Page 40

38 D01-051en202111 Manual TriBox3
Advanced
Use
Malfunction &
Maintenance
Commis-
sioning
Introduction
General
Information
FAQTechnical Data Warranty
Customer
Service
Contact
Keyword
Index
AccessoriesUse
Use // TriBox3
The subitem “Cleaning” (menu item “Options”) allows the user to set the cleaning intervals.
To make use of an automatic cleaning interval, this must rst be activated by checking the box and setting a
cleaning interval. The cleaning time and the pause before the measurement can also be dened here.
Cleaning can also be triggered and dened whether the valve and the relay are activated during cleaning.
When the valve switches, the air must come out of the outlet and stop completely
when the switching procedure has nished. If air is not released or if the valve
does not close correctly at the end of the switching procedure, both hoses must
be swapped.
NOTICE
The compressed air valve must never be exposed to pressure greater than 0.7 Mpa
(7 bars). Otherwise, the valve can be damaged.
NOTICE
To ensure that settings made are not lost when reconguring, it is essential to save a restore
point beforehand.
Please note that the measurement and cleaning intervals should be matched to each other
to avoid suspension of measurements. If this is necessary, use the recommended settings
described in the table below.