triOS TriBox3 - Accessories; AirShot2 System; Modbus Distributor Box; Compass Sensor

72 D01-051en202111 Manual TriBox3
Use
Advanced
Use
Malfunction &
Maintenance
Commis-
sioning
Introduction
General
Information
FAQTechnical Data Warranty
Customer
Service
Contact
Keyword
Index
Accessories
Accessories // TriBox3
8 Accessories
8.1 AirShot2
The convenient AirShot2 compressed air cleaning
system uses pulses of compressed air rather than a
continuous airow. This signicantly reduces the re-
quired volume of air and allows the system to be very
compact.
Additionally, compressed air pulses clean more e󰀨ec-
tively than a continuous stream of air, which makes the
AirShot2 a valuable addition.
The AirShot2 can be used instead of a conventional
compressor and can be controlled directly via the Tri-
Box.
8.2 Modbus Distributor Box
5-input M12 connector
This distributor box allows a controller input to be ex-
panded to allow ve inputs, allowing signicantly more
sensors to be controlled via one controller then before.
8.3 Compass
3-axis compass
The 3-axis compass determines the compass direc-
tion, the angle of inclination and the angle of rotation.
It can be mounted together with sensors to bring the
measured values in connection with the position.
8.4 TAMMO / AdamE
TAMMO is an expansion module for the TriBox3 that
converts analogue signals to the RS-485 Modbus RTU
protocol. The analogue-to-Modbus module o󰀨ers a
total of two current inputs, where both the parameter
and the unit can be set for two parameters.
Variant AdamE is only valid in connection with the use
of TriBox3 EGCWA with 8-digit serial number starting
with 751xxxxx.