triOS TriBox3 - Calling up the Recovery Point

65D01-051en202111 Manual TriBox3
Use
Advanced
Use
Commis-
sioning
Introduction
General
Information
FAQ Technical DataWarranty
Customer
Service
Contact
Keyword
Index
Accessories
Malfunction &
Maintenance
TriBox3 // Malfunction & Maintenance
6.3.4 Calling up the Recovery point
The subitem “Recovery Point” also stores settings. For your safety, a recovery point
should always be stored when making changes to settings such as scaling factors,
analog outputs or measurement intervals.
In this illustration, a recovery point has already been saved in addition to the factory settings.
When the device is reset to the factory settings, all user-specic settings are lost!
To make sure that all previously entered settings are saved and updated, the controller
should be restarted after every reconguration. After the restart, a recovery point should be
stored.