Triotech Storm VR - Page 41

Maintenance and Repairs
Storm-OM-001
41
28 February 2020
This document, including the information contained herein, is proprietary to Triotech Amusement Inc.
13- The actuator can now be removed safely
from the motion base.
14- The complete actuator assembly and
cable.
Note: actuator
and installed on the new actuator, if newly revised replacement plates are not
required.
15- Begin by removing the bolt holding
t .
16- Apply a drop of blue loctite threat
compound to the bolt before screwing
it in the new actuator.
The instructions can now be followed in reverse to complete the installation of the new
actuator.