Triton AMORE User Manual

23
CLEANING THE FILTER
It is recommended that the filter is periodically
cleaned in order to maintain the performance of
the shower. It is essential that this operation is
carried out by a competent person.
• SWITCH OFF the electricity and water supply
at the mains.
• The inlet filter is situated inside the water inlet
fitting (g.24). To gain access to the lter,
remove the cover and bottom trimplate.
• Unscrew the lter cap from the bottom of the
inlet pipe.
• Inspect the ‘O’ ring for damage when the
filter cap is removed.
• When cleaning the filter, DO NOT use a sharp
object as it will cause damage. It is preferable
to use an old toothbrush or similar.
• To reassemble, follow the procedure in
reverse.
• Make sure that the sealing ‘O’ ring is in place.
• DO NOT over tighten the filter cap on
reassembly.
Instructions for installers and service engineers only
INSTRUCTIONS FOR INSTALLERS AND SERVICE ENGINEERS ONLY
Instructions for installers and service engineers only
Fig.24
Filter
‘O’ ring
Filter cap

Triton AMORE Specifications

General

Type	Electric Shower
Start/Stop Button	Yes
Phased Shutdown	Yes
Warranty	2 years
Cable Entry Points	Bottom
Material	Plastic
Finish	White