ADJUSTING THE SPRAYHEAD
(Aire, Exe and Nene)
Three sprayhead patterns are available (fig.36).
Adjustment is by turning the bezel on the
sprayhead in either direction until the desired
pattern is obtained.
MAXI
A full spray perfect for a relaxing shower.
ULTRA
A focused spray for a refreshing, satisfying
shower.
JET
A concentrated spray for an exhilarating
shower.
CLEANING
Do not use abrasive or solvent cleaning
fluids. The shower unit, riser rail, hose,
etc. should be cleaned using a soft cloth
and warm water.
It is advised before cleaning, to turn the
isolation switch off, thus avoiding the shower
being accidentally switched on.
IT IS IMPORTANT TO KEEP THE SPRAYHEAD
CLEAN TO MAINTAIN THE PERFORMANCE OF
THE SHOWER. The hardness of the water will
determine the frequency of cleaning. For
example, if the shower is used every day in a
very hard water area, it may be necessary to
clean the sprayhead on a weekly basis.
Sprayhead removal procedure
Remove the sprayhead from the hose. Remove
the sprayhead cartridge (fig.37) by turning the
bezel anti-clockwise until a ‘stop’ is felt.
Overcome the ‘stop’ by continuing to turn anti-
clockwise until the cartridge and bezel come
out.
Clean the cartridge with a suitable brush or
preferably leave to soak overnight in a mild
proprietary descalent. Ensure all traces of scale
are removed and thoroughly rinse in clean
water afterwards.
Refit the cartridge by screwing in clockwise until
tight and replace the sprayhead on the hose.
UltraMaxi
Jet
Fig.36
Fig.37
To Next Page
Loading...
Need help?
General
