Bar Mixer Shower
9
INSTALLATION
PREPARING THE SHOWER
Check the contents to make sure all parts are
present.
Before starting the installation, make sure all the
openings on the valve are carefully covered to
stop ingress of any debris etc. while routing the
supply pipework.
The shower is suitable for exposed installation
onto solid wall, a stud partition wall, dry lined
wall or xing to a laminate cubicle or panel.
SITING OF THE SHOWER & ACCESSORIES
Refer to g.6 for correct siting of the shower.
The shower should be positioned as detailed,
with all controls within comfortable reach of the
user.
The shower head can be positioned above or to
either side of the shower.
The shower must be installed in a position that
allows for easy access for future maintenance and
commissioning.
IMPORTANT: This product is not supplied with a
hose retainer. Water regulations require the ttig
of a double check valve or similar device, in the
suppply pipework to prevent backow.
INSTALLING BAR MIXER BRACKETS
Guidance on installing the bar mixer brackets
(g.7) can be found in a separate instruction
book (supplied).
Please read the instructions carefully.
Read through the whole of the guide before
beginning installation.
The wall brackets installation must be carried
out by a suitably competent person and in the
sequence of the instruction book.
Shower head can
be mounted
either side of the
mixer
Height of
shower head
to suit user’s
requirements
*Fig.6
Fig.7
*Diagrammatic view – not to scale.
For illustration purposes only.
To Next Page
Loading...
Need help?
General
