30
General Information
Ignition Switch
1. Ignition Switch lock
2. OFF position
3. ON position
4. PARK position
Engine Immobiliser
The ignition switch housing acts as the
antenna for the engine immobiliser.
When the ignition switch is turned to the OFF
position and the ignition key is removed, the
engine immobiliser is on (see page 28). The
engine immobiliser is turned off when the
ignition key is in the ignition switch and it is
turned to the ON position.
Switch Location
The ignition switch is located in line with the
rear edge of the fuel tank, on the right hand
side of the motorcycle.
Switch Operation
This is a three position, key operated switch.
The key can be removed from the switch only
when it is in the OFF or P (PARK) positions.
To turn the switch from OFF to ON, insert
the key and turn the key clockwise to the ON
position.
To turn the switch from ON to PARK, push
the key barrel further into the lock and turn
clockwise to the PARK position. Use the PARK
position only when temporarily leaving the
motorcycle in a situation where the tail,
licence and position lights must remain on.
To turn the key back to OFF, turn the key
anti-clockwise.
For reasons of security and safety, always
turn the ignition to the OFF or PARK
position and remove the key when leaving
the motorcycle unattended.
Any unauthorised use of the motorcycle
may cause injury to the user, other road
users and pedestrians and may also cause
damage to the motorcycle.