38
General Information
Side Stand
1. S i d e s t a n d
The motorcycle is equipped with a side stand
on which the motorcycle can be parked.
Note:
• When using the side stand, always
turn the handlebars fully to the left
and leave the motorcycle in first gear.
Whenever the side stand is used, before
riding, always ensure that the stand is fully up
after first sitting on the motorcycle.
For instructions on safe parking, refer to the
'How to Ride the Motorcycle' section.
Side Panels
1. Side panel (right hand shown)
2. Grommets
Side panel removal is required to access the
fuse box and the tool kit Allen key.
To remove either side panel, grasp the panel
firmly in both hands and pull the panel away
from the motorcycle until it clears the three
retaining grommets (leaving the grommets in
place).
To refit, position the three locating dowels to
the grommets, then press firmly to secure the
panel.
Ensure the panel is correctly located over the
upper and lower locating dowels.
Finally, grasp the panel and ensure that it is
fully retained.
The motorcycle is fitted with an interlock
system to prevent it from being ridden
with the side stand in the down position.
Never attempt to ride with the side stand
down or interfere with the interlock
mechanism as this will cause a dangerous
riding condition leading to loss of
motorcycle control and an accident.
To Next Page
Loading...
