74
Maintenance and Adjustment
Disposal of Used Engine Oil and Oil
Filters
To protect the environment, do not pour oil
on the ground, down sewers or drains, or
into watercourses. Do not place used oil filters
in with general waste. If in doubt, contact
your local authority.
Oil Specification and Grade
Triumph's high performance fuel injected
engines are designed to use 10W/40 or
10W/50 semi or fully synthetic motorcycle
engine oil that meets specification API SH
(or higher) and JASO MA, such as
Castrol Power 1 Racing 4T 10W-40 (fully
synthetic) engine oil, sold as Castrol Power RS
Racing 4T 10W-40 (fully synthetic) in some
countries.
Do not add any chemical additives to the
engine oil. The engine oil also lubricates the
clutch and any additives could cause the
clutch to slip.
Do not use mineral, vegetable, non-detergent
oil, castor based oils or any oil not
conforming to the required specification. The
use of these oils may cause instant, severe
engine damage.
Cooling System
To ensure efficient engine cooling, check the
coolant level each day before riding the
motorcycle, and top up the coolant if the level
is low.
Note:
• A year-round, Hybrid Organic Acid
Technology (known as Hybrid OAT
or HOAT) coolant is installed in the
cooling system when the motorcycle
leaves the factory. It is coloured
green, contains a 50% solution of
ethylene glycol based antifreeze,
and has a freezing point of -35°C
(-31°F).
To Next Page
Loading...
Need help?
General
