31
ERROR CODE MAIN REASON SOLUTION TO ERROR
E01 This error indicates a possible
message failure between computer
and bottom control board.
1. Check that the computer and bottom control
board wires are connected correctly.
2. Change the entire control board.
E02 This error indicates a protection
against exploding.
1. If there is a bad connection with an open circuit
in the motor, please change to a new motor or
check the connection.
2. If the power cable has a puncture. Please
change to a new Power cable or control board.
E03 This error indicates a possible no
sensor signal.
1. Check that the speed sensor wire connection is
correct. If not, then reconnect the wire
2. Check if the speed sensor is damaged. If it is,
then change to a new speed sensor.
E04 This error indicates a possible incline
motor study failure.
1. Check if the incline motor wires have been
connected correctly. If not, re-connect them.
2. Check if wire on the incline motor is damaged.
Change wire if required.
After checking all the above, press the study key on
the incline motor to reset.
E05 This error indicates a possible
current overload.
1. If current over load has been detected or the
motor is stuck, this will cause an excessive
current and the machine will start self-
protecting its system. Adjust the machine and
restart.
2. Check if the motor has a noise coming from the
it or if the motor / bottom control board has
burnt out. If it has burnt out, then change to a
new motor and/or bottom control board. Use
correct voltage moving forward.
E06 Cannot pass self checking 1. Turn the power on and off again.
2. Change the controller.
E07 / E08 Program and data error 1. Change the controller.
ERROR CODES
TROUBLE SHOOTING GUIDE
#22M07T003 TR310 TREADMILL - USER MANUAL.indd 31 2022/08/29 3:27 PM
To Next Page
Loading...
