BA 8010_3.0_EN (10/2016) 29 / 68
1 Top lid
If the Top lid is opened, no data is processed. After closing the Top lid,
the device is not ready to process commands for 5 seconds. If the
protection cover is opened during operation, the motion system is
stopped and laser source is turned off.
Please note, that the laser tube is switched off immediately and
consequently the result of the engraving is incomplete. During
processing of commands the protection cover must only be opened
after pressing the "Pause" button.
2 Light Barriers – Autofocus sensor
Used for the automatic focusing of the work piece (optional).
Do NOT use this option when processing transparent materials.
3 Service Access Panel
Only to be opened by trained technical service personnel.
4 Connection Socket for Rotary Engraving Attachment
Connector for the rotary engraving attachment (option).
Supplies the rotary engraving attachment with the required electric
signals.
5 Focusing head
The lens that focuses the laser beam onto the material is mounted
inside the focusing head.
6 X axis
The motion system is that part that performs the mechanical
movements in X direction (horizontal) and Y direction (vertical). The X
axis is visible in the working area.
7 Ruler
To Next Page
Loading...
Need help?
General
