BA 8010_3.0_EN (10/2016) 33 / 68
4.2 ON/OFF Switch
Switches the mains supply ON/OFF.
The following conditions must be fulfilled for correct start up:
- unrestricted freedom of motion of the mechanics
- no materials under the engraving table
- protection covers closed
If the top lid or any other interlock secured cover (mainenance panel)
is open, an acoustic signal sounds and the status display flashes fast
in green.
Íf all interlock-secured covers are closed, immediately after being
switched on, the device starts the referencing process. When the
referencing process is completed correctly, an acoustic signal sounds
and the device is ready for operation. The readiness for operation is
additionally displayed by green (slow) flashing of status display.
Before switching on the device, the user must make sure that no
objects of any kind are located inside the operating space, which could
limit or obstruct the mechanics of the device.
When switching off the mains supply, all processing data is lost.
To Next Page
Loading...
Need help?
General
