BA 8010_3.0_EN (10/2016) 6 / 68
1.2 Designated Use
The Trotec Speedy 100, is used for engraving and cutting of signs, stamps and suchlike.
A wide variety of materials such as rubber, acrylic, coated metal, tin, special steel, anodized
aluminum, cork, cardboard, glass, leather, marble, several plastics and wood can be
processed on the laser.
The engraving process must only be performed with a perfectly adjusted
machine (see also Section 4 OPERATION).
For cutting applications from 45W the use of the cutting table is absolutely
necessary.
Use of the system in other areas is against the designated use. The
manufacturer does not admit liability for damage to personal and/or equipment
resulting from such use.
The system must only be operated, maintained and repaired, by personnel
that are familiar with the designated field of use and the dangers of the
machine!
Non-observance of the instructions for operation, maintenance and repair
described in this Operation Manual excludes any liability of the manufacturer
if a defect occurs.
Caution when processing conductive materials (carbon fibers,…)! Conductive
dust or particles in the ambient air might damage electrical components and
lead to short circuits. Bear in mind that those defects are NOT warranted.
1.3 Disposal remarks
Do not dispose the machine with domestic waste!
Elektronic devices have to be disposed according to the regional directives
on electronic and electric waste disposal.
In case of further questions, please ask your supplier. He might take care of
proper disposal.
To Next Page
Loading...
Need help?
General
