Troxler 3440 Plus - Set Output Destination

8–10
SET OUTPUT DESTINATION
As described on page 8–7, the gauge can print (or upload) project
data to a computer or serial printer connected to the serial port, or to
a USB printer or flash drive (also referred to as a “thumb drive”)
connected to the USB port.
NOTE
The USB port is included only on Model 3440 Plus
gauges.
NOTE
The opening for the USB port will accept a device with
maximum dimensions of 10 mm (0.40 in.) high by
29 mm (0.79 in.) wide.
NOTE
A list of USB devices that are compatible with the gauge
is available on the following page of the Troxler website:
www.troxlerlabs.com/PRODUCTS/PRODLIT/otherlit.shtml
To select the output destination, press 〈6〉 at the Projects menu
shown on page
8–2. The gauge displays:
Use the numeric keys to select the desired output destination. The
gauge enables the selected option, displays a brief confirmation
message, and returns to the Projects menu. Press
〈ESC〉 to return
to the Ready screen.
 
  
   
   