Troxler 3440 Plus - Unpacking and Inspection

Model 3430 Plus & 3440 Plus
1–7
WARNING
The source rod should always be in the SAFE
position when the gauge is not in use.
UNPACKING AND INSPECTION
Troxler recommends that the operator wear a dosimeter while
working with the gauge. Upon receipt of the gauge from the factory,
perform a complete inspection and inventory. If the shipping case
and/or any other part or accessory appears damaged, notify the
carrier and your Troxler Representative immediately.
For shipping to another location or back to the factory, save the box
and any packing material. For shipping instructions and regulations,
please see Appendix B.
Check the shipping case for the following:
♦ Gauge
♦ Reference Standard Block
♦ Drill Rod
♦ Scraper Plate/Drill Rod Guide
♦ Extraction Tool
♦ AC Charger
♦ DC Adapter (for a vehicle cigarette lighter)
♦ Manual of Operation and Instruction
♦ Gauge Warranty
♦ Source Certificate
♦ Transportation Guide (This guide refers to U.S. standards. All
other countries please refer to local regulations. In the absence
of local regulations, please use this guide as a reference only)
NOTE
Charge the batteries for four hours prior to initial use.
1. INTRODUCTION