Troxler 3440 Plus - PRINTING (UPLOADING) PROJECT DATA

Model 3430 Plus & 3440 Plus
Appendix H–3
6. Click OK. The Troxler Data – HyperTerminal window is
displayed, where Troxler Data is the icon name entered in
step 3.
7. From the toolbar, click on File and select Save from the
dropdown menu.
8. Close the Troxler Data – HyperTerminal window by
selecting Exit from the File menu.
EQUIPMENT CONNECTION
Connect the gauge to the computer using the appropriate serial cable
(see the list of Options on page C–29). Connect the gauge’s serial
port (see Figure 3–1 on page 3–2) to the computer COM port
selected in step 4 of the HyperTerminal Setup section on the
previous page.
PRINTING (UPLOADING) PROJECT DATA
To print (upload) project data from the gauge to the computer:
1. On the computer, click on the Start button, then select the
Programs menu and the Accessories folder. Select the
Communications subfolder, then select the HyperTerminal
icon.
2. From the HyperTerminal window, double-click on the
Troxler Data – HyperTerminal icon (where Troxler Data is
the icon name entered in the HyperTerminal Setup section on
the previous page). The Troxler Data – HyperTerminal
window is displayed.
H. PRINTING DATA