INSTALLING AND USING ALKALINE BATTERIES
To power the gauge using five AA alkaline batteries, install the
batteries as follows:
✓
Turn the gauge off.
✓
Loosen the four captive screws on the control unit.
✓
Carefully lift the control unit from the gauge.
✓
Unplug the ribbon cable from the control unit.
✓
Install five standard AA alkaline batteries into the battery holder
(see Figure C–2).
✓
Set the battery select switch to the ALKALINE position.
✓
Plug the ribbon cable into the control unit.
✓
Attach the control unit to the gauge with the four captive
screws.
To Next Page
Loading...
