Model 3430 Plus & 3440 Plus
If a project is active (see Chapter 8) and the Auto-Store
function (see page 8–12
) is enabled, press 〈ESC〉 or
〈ENTER/START〉 to continue. For each measurement, the
gauge can store a location description of up to 12
characters, as well as a note of up to 15 characters. Follow
the prompts to enter location information and/or a note.
If a project is active but the Auto-Store function is not
enabled:
Press 〈STORE〉 to store the results. Follow the prompts
to enter location information and/or notes. For more
information on storing results manually, see page
8–14.
Press 〈ESC〉 to return to the Ready screen without
storing the results. Note that, until another measurement
has been taken, the results can be recalled as described
on page
4–17 and stored later.
✓
Lift the gauge from the test site by the source rod handle. This
returns the source rod to the SAFE position. When not taking
readings, always keep the source rod in the SAFE position.
To Next Page
Loading...
