TRU-BOLT 1742002 - Consumer Friendly Message Guide; Programming Records

Page 20
NOTE: When battery is under low voltage, the lock will give the (Low Battery Warning: Beeps and
LED ashes red for 5 seconds). During this time your lock can still work. However once the voltage
is lower than 4.3V (called Super-Low Voltage), the operation of the locking and unlocking will not
work and user must replace batteries immediately.
Unlock / Valid programming: 1 long beep and LED illuminates green
Lock: 2 short beeps and LED illuminates red
Invalid Programming: 2 short beeps and LED ashes red twice
Low Voltage: Beeps for 5 seconds - 10 times
Super Low Voltage: 4 short beeps and LED ashes red four times
4 Incorrect code entry attempts: 2 short beeps and LED illuminates red each attempt
Power on: 1 long beep and 1 short beep and LED illuminates green
Chip Reset: 1 long beep and 1 short beep and LED illuminates green
(may occur several times or once in a while)
Lock Error: 3 long beeps LED ashes red three times
Repeat operation after Lock Error: 2 short beeps three times LED ashes red six times
CONSUMER FRIENDLY MESSAGE GUIDE
My Codes: Date Created
Programming Code (6 digits) / /
User Code 01 (4-8 digits) / /
User Code 02 (4-8 digits) / /
User Code 03 (4-8 digits) / /
User Code 04 (4-8 digits) / /
User Code 05 (4-8 digits) / /
User Code 06 (4-8 digits) / /
User Code 07 (4-8 digits) / /
User Code 08 (4-8 digits) / /
User Code 09 (4-8 digits) / /
User Code 10 (4-8 digits) / /
PROGRAMMING RECORD