~ 3 ~
SECTION 1 – USING YOUR POWRTOUCH FREEDOM SAFELY
1.1 SAFETY CHECKS REQUIRED PRIOR TO USING YOUR POWRTOUCH FREEDOM
PLEASE READ CAREFULLY:
Before moving the caravan with the Powrtouch Freedom, for safety reasons it should always
be tested first, to do this turn on the Powrtouch Freedom at the Isolation switch – DO NOT
PUT THE ROLLERS ON TO THE TYRES. With the rollers off the tyres check the handset
functions drive the rollers correctly. Once this test has been satisfactorily completed only then
should you engage the rollers to the tyres and commence to move the caravan.
IF IN DOUBT CONTACT POWRTOUCH
1.2 EMERGENCY SWITCH OFF/STOP
NB. In the unlikely event of the Powrtouch Freedom malfunctioning, the system can be
switched off by pressing either of the ‘On’ buttons (D or F) on the handset. Then turn off the
Powrtouch Freedom at the Isolation switch and remove the key. DO NOT switch the
Powrtouch Freedom back on before consulting a qualified Powrtouch Engineer.
1.3 SAFETY & TECHNICAL AWARENESS
Please read the following instructions and technical information carefully and become familiar
with the various components and controls prior to assembly and/or operation. Safety must
always be the first consideration in fitting and operation. Failure to comply with these
instructions could invalidate your Powrtouch guarantee. If you are in any doubt about the
assembly or operation of the product consult a qualified Powrtouch Engineer, for which contact
details are shown on the front cover.
• The Powrtouch Freedom Caravan Mover (except handset) is a 12volt DC powered
device and it should not under any circumstances be powered by any other power
source than a 12volt DC leisure battery. NB. Using the Powrtouch Freedom with the
caravan connected to the 240volt mains could cause damage to the caravan
internal charging system.
To Next Page
Loading...
