Truma Powrtouch Freedom - Engagement of the Rollers Onto the Tyres

~ 6 ~
2.5 ENGAGEMENT OF THE ROLLERS ONTO THE TYRES
Engagement of the Rollers on to the Tyres Using the Supplied Wrench
To engage the rollers onto the tyres, locate the wrench onto the hexshaft (see picture above)
and turn in the direction shown, after 200 degrees the over locking cam system will lock the
rollers in the engaged position. On the Powrtouch Freedom models the start position for the
wrench should be as low as possible to the ground with the handle pointing away from the
rollers. Always take great care with this operation as the over locking cam system together with
its return spring require some force to move the rollers into position against the tyres. This
operation only needs to be done from one side of the caravan as the Freedom is fitted with a
Powrbar as standard. Your Powrtouch fitter or supplier will show you how to carry out this
operation safely.
If in doubt consult a qualified Powrtouch Engineer. NB. Always check that BOTH rollers
are fully engaged on to the tyres of the caravan before removing the handbrake.
Once the Rollers are engaged ONLY then disengage the handbrake when you are ready
to use the Powrtouch Freedom.