TSC MH241 Series User Manual

29
Wrinkle happens from label lower left to upper right direction
 Make sure the Print head Pressure Adjustment Knob is in correct position for the current media. Ex: 1~2”, 3~4”
 Turn the screw counterclockwise per level and print to see if the winkle has gone.
 If the ribbon tension adjustment knob has positioned on the level of outermost side but dosnt’t improve the ribbon wrinkle,
please switch the print head pressure at 1 level and print the label again to check if the wrinkle is gone.
 If the wrinkle can’t be avoided, please contact the Customer Service Department of your purchased reseller or distributor for
service.
Feed Direction

TSC MH241 Series Specifications

General

Resolution	203 dpi
Max. Print Width	104 mm
Interface	Ethernet
Scanning Method	Thermal Transfer/Direct Thermal
Supported Barcode Types	1D Barcodes
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	5°C to 40°C
Storage Temperature	60°C
Humidity	25-85% non-condensing
Weight	MH241/MH241T/MH241P: 15 kg MH341/MH341T/MH341P: 15 kg MH641/MH641T/MH641P: 15 kg