TSC MH361T Series

- 48 -
5.8 Diagnostics
Item
Description
Print Config.
This feature is used to print current printer configuration to the label. On
the configuration printout, there is a print head test pattern, which is
useful for checking if there is any dot damage on the print head heater
element.
Note:
Checking dot damage requires 6” wide paper width.
Self-test printout
Model name
F/W version
Firmware checksum
Printer S/N
TSC configuration file
System date
System time
Printed mileage
(meter)
Cutting counter
Print speed (inch/sec)
Print darkness
Label size (inch)
Gap distance (inch)
Gap/black mark sensor
intension
Code page
Country code
Diagnostics
Print Config.
Dump Mode
Print Head
Display
Sensor
Diag Gap
Diag Black Mark
Diag Ribbon End