TSC MH361T Series User Manual

- 53 -
6 Troubleshooting
The following guide lists the most common problems that may be encountered when operating this
bar code printer. If the printer still does not function after all suggested solutions have been
invoked, please contact the Customer Service Department of your purchased reseller or distributor
for assistance.
Problem Possible Cause Recovery Procedure
Power indicator does not
illuminate
* The power cord is not
properly connected.
* Plug the power cord in printer and outlet.
* Switch the printer on.
Carriage Open
* The printer carriages are
open.
* Please close the print carriages.
Not Printing
* Check if interface cable is
well connected to the
interface connector.
* Check if wireless or Bluetooth
device is well connected
between host and printer.
* The port specified in the
Windows driver is not correct.
* Re-connect cable to interface or change
a new cable.
* Please reset the wireless device setting.
* Select the correct printer port in the
driver.
* Printhead’
s harness connector is not well
connected with printheat. Turn off the
printer and plug the connector again.
* Check your program if there is a
command PRINT at the end of the file
and there must have CRLF at the end of
each command line.
No print on the label
* Label or ribbon is loaded not
correctly.
* Use wrong type paper or
ribbon
* The print density setting is
incorrect.
* Follow the instructions in loading the
media and ribbon.
* Ribbon and media are not compatible.
* Verify the ribbon-inked side.
* Reload the ribbon again.
* Clean the printhead.
* Set the correct density with media
No Ribbon
* Running out of ribbon.
* The ribbon is installed
incorrectly.
* Supply a new ribbon roll.
* Please refer to the steps in user’s
manual to reinstall the ribbon.
No Paper
* Running out of label.
* The label is installed
incorrectly.
* Gap/black mark sensor is not
calibrated.
* Supply a new label roll.
* Please refer to the steps in user’s
manual to reinstall the label roll.
* Calibrate the gap/black mark sensor.
Paper Jam
* Gap/black mark sensor is not
set properly.
* Make sure label size is set
properly.
* Labels may be stuck inside
the printer mechanism.
* Calibrate the media sensor.
* Set media size correctly.
* Remove the stuck label
inside the printer
mechanism.
Take Label
* Peel function is enabled.
* If the peeler module is installed, please
remove the label.
* If there is no peeler module in front of
the printer, please switch off the printer
and install it.
* Check if the connector is plugging
correctly.

TSC MH361T Series Specifications

General

Brand	TSC
Model	MH361T Series
Category	Barcode Reader
Language	English