TSC TE200 series Service Manual

43
TE200/TE210/TE300/TE310 Series
Bar Code Printer Service Manual
5. MAINTENANCE
This session presents the clean tools and methods to maintain your printer.
1. Please use one of following material to clean the printer.
 Cotton swab (Head cleaner pen)
 Lint-free cloth
 Vacuum / Blower brush
 100% ethanol
2. The cleaning process is described as following
Printer Part
Method
Interval
Print Head
1. Always turn off the printer
before cleaning the print head.
2. Allow the print head to cool for
a minimum of one minute.
3. Use a cotton swab (Head
cleaner pen) and 100% ethanol
to clean the print head surface.
Clean the print head when changing a
new label roll
Platen Roller
1. Turn the power off.
2. Rotate the platen roller and
wipe it thoroughly with 100%
ethanol and a cotton swab, or
lint-free cloth.
Clean the platen roller when changing
a new label roll
Tear Bar/Peel
Bar
Use the lint-free cloth with 100%
ethanol to wipe it.
As needed
Sensor
Compressed air or vacuum
Monthly

TSC TE200 series Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Resolution	203 dpi
Processor	32-bit RISC CPU
Max Print Width	108 mm
Max Print Speed	6 ips
Memory	8 MB Flash, 8 MB SDRAM
Interface	USB 2.0
Max Print Length	110 inches
Media Type	Labels, Tags, Tickets
Media Width	25.4 mm - 112 mm
Media Core Diameter	25.4 mm (1 inch), 76.2 mm (3 inch)
Label Length	0.39 inches to 110 inches
Ribbon Width	33.8 mm ~ 110 mm (1.33" ~ 4.33")
Ribbon Core Diameter	0.5 inches
Power	100-240V AC, 50-60Hz
Dimensions	204 mm (W) x 164 mm (H) x 280 mm (D)
Operating Temperature	5°C to 40°C
Storage Temperature	-40°C to 60°C
Operating Humidity	25% to 85% non-condensing
Media Thickness	0.06 ~ 0.19 mm (2.36 ~ 7.48 mil)