TSC TH240 Series User Manual

66
Item
Description
Default
Darkness
Sets the print darkness. Setting range: 0 to 30.
16
Print Speed
Sets the print speed. Setting range: 1.5 to 8 ips (203 dpi), 1.5 to 6 ips (300 dpi).
5 (203 dpi)
4 (300 dpi)
Tear Off
Specifies the stop position of the media after a label is printed. Setting range: -120 to 120 dots.
0
Print Mode
Sets the print mode.
 Tear Off: Allows users to tear off a label after it is printed.
 Cutter: Enables the cutter mode.
 Peel Off: Enables the peel-off mode.
Tear Off
Print Width
Specifies the print width. Setting range: 2 to 864.
812
List Fonts
Prints the list of all linked fonts saved in the printer’s memory.
List Images
Prints the list of all linked images saved in the printer’s memory.
List Formats
Prints the list of all linked label formats saved in the printer’s memory.
List Setup
Prints the printer’s configurations.
Control Prefix
Sets the control command prefix.
7E (~)
Format Prefix
Sets the control format prefix.
5E (^)
Delimiter Char
Sets the delimiter character to separate the command parameters.
2C (,)
Media Power Up
Configures the printer to take specific action after powering on the printer.
 No Motion: The printer will take no action. The sensor values and media position will not be
changed.
 Length: The printer will detect the length of a label and then advance the label to the correct
position.
 Calibration: The printer will run the calibration and then advance the media to the correct
position according to the calibration results.
 Feed: The printer will advance the label to the configured position.
No Motion

TSC TH240 Series Specifications

General

Brand	TSC
Model	TH240 Series
Category	Barcode Reader
Language	English