3.3 Loading the Ribbon
1. Open the printer’s top cover by pulling the top cover open levers located on each
side of the printer and lifting the top cover to the maximum open angle.
2. Open the ribbon access cover.
Note:
1. In normal printing mode, ribbon access cover can be opened while opens the top cover.
Ribbon access cover can be closed while top cover is open or close.
2. In peeler and cutter mode, please open the top cover then the ribbon access cover can be
opened or closed.
3. Insert the ribbon right side onto the supply hub. Align the notches on the left side
and mount onto the spokes.
4. Insert the paper core right side onto the rewind hub. Align the notches on the left
side and mount onto the spokes.
To Next Page
Loading...
