3.4 Loading the Media
3.4.1 Loading the media
1. Open the printer top cover by pulling the tabs located on each side towards the front
of the printer, then lift the top cover to the maximum open angle.
2. Separate and hold open the media holders.
3. Place the roll between the holders and close them onto the core.
4. Press down the media holder lock switch to hold the label roll firmly.
5. Place the paper, printing side face up, through the media sensor and place the label
leading edge onto the platen roller. Move the media guides to fit the label width by
turning the guide adjuster knob. Disengage the top cover support and close the top
To Next Page
Loading...
