3.4.3 Loading Media in Peel-off Mode (Option)
1. Refer to section 3.4.1 to load the media.
2. Feed the paper, printing side facing up, through the paper guide and pass over the
platen.
3. Move the media guides to fit the label width by turning the guide adjuster knob.
4. Use “Diagnostic Tool” to set the media sensor type and calibrate the selected sensor.
(Start the “Diagnostic tool” Select the “Printer Configuration” tab Click the
“Calibrate Sensor” button) Please refer to the diagnostic utility quick start guide for
more information.
5. Open the peel-off panel by pulling it out.
6. Lead the media through the backing paper opening, beneath the peel-off roller.
7. Push the peel-off panel back to the printer
To Next Page
Loading...
