To Next Page
C
cody05Sep 16, 2025
Why is the RTC time incorrect when I reboot my TSC Printer?
- CchristinejohnsonSep 16, 2025
If the RTC time is incorrect when you reboot your TSC Printer, check if there is a battery on the main board.
Why is the RTC time incorrect when I reboot my TSC Printer?
If the RTC time is incorrect when you reboot your TSC Printer, check if there is a battery on the main board.
Why is my TSC Printer not printing anything on the label?
If your TSC Printer is not printing on the label, consider the following: * Ensure the label and ribbon are loaded correctly, following the loading instructions. * Verify that the ribbon and media are compatible. * Reload the ribbon, ensuring the inked side is correct. * Clean the printhead. * Check that the print density setting is correct.
How to fix poor print quality on my TSC Printer?
To resolve poor print quality on your TSC Printer: * Reload the ribbon and media. * Clean the print head and platen roller. * Adjust the print density and print speed. * Run a printer self-test to check the print head test pattern for missing dots. * Change to a proper ribbon or label media. * Adjust the printhead pressure adjustment knob.
What to do if my TSC Printer says 'No Paper'?
If your TSC Printer indicates 'No Paper', consider these solutions: * Supply a new label roll. * Reinstall the label roll, referring to the user manual for guidance. * Calibrate the gap/black mark sensor.
Why does my TSC Printer skip labels when printing?
If your TSC Printer is skipping labels, try these solutions: * Check if the label size is set up correctly. * Calibrate the sensor using Auto Gap or Manual Gap options. * Clear any dust from the GAP/Black mark sensor using a blower.
How do I resolve wrinkle problems when printing with my TSC Printer?
To address wrinkle problems with your TSC Printer: * Refer to section 4.2. * Set a suitable print density for good print quality. * Ensure the label guide touches the edge of the media guide.
What does 'Carriage Open' mean on my TSC Printer?
If your TSC Printer displays 'Carriage Open', please close the print carriages.
Why is the peel sensor not working on my TSC Printer?
If the peel sensor is not working on your TSC Printer: * Ensure that the media goes through the Peel sensor. * Plug the connect cable correctly.
Why is the left side printout position incorrect on my TSC Printer?
If the left side printout position is incorrect on your TSC Printer: * Set the correct label size. * Fine-tune the Shift X parameter by pressing [MENU] [SELECT] x 3 [DOWN] x 5 [SELECT].
Why is my TSC Printer printing a gray line on blank labels?
If your TSC Printer is printing a gray line on blank labels, clean the print head and the platen roller.
General| Print Speed | 4 ips / 6 ips |
|---|---|
| Memory | 512 MB Flash, 512 MB SDRAM |
| Interface | USB 2.0, Serial, Ethernet |
| Type | Industrial Printer |
| Print Method | Thermal Transfer / Direct Thermal |
| Print Resolution | 203 dpi |
| Communication Interface | USB 2.0, Serial, Ethernet |
| Label Thickness | 0.003" (0.076 mm) ~ 0.012" (0.305 mm) |
| Power Supply | 100 - 240 VAC, 50/60 Hz |
| Operating Temperature | 5 ~ 40°C (41 ~ 104°F) |
| Storage Temperature | -40 ~ 60°C (-40 ~ 140°F) |
| Resolution | 203 dpi |
| Operating Humidity | 20 - 85% RH (non-condensing) |
