Why is my TSC Printer not reading the SD card?
If your TSC Printer is unable to use the SD card: * Ensure you are using a supported capacity SD card. * Reinsert the SD card. * Refer to section 2.2.3 for supported SD card specifications and approved manufacturers.
How to fix a TSC Printer when the power indicator doesn't light up?
If the power indicator on your TSC Printer does not illuminate: * Ensure the power cord is properly connected to both the printer and the outlet. * Switch the printer on.
What to do if my TSC Printer is not printing?
If your TSC Printer isn't printing, there are several potential solutions: * Ensure the interface cable is securely connected, or try a new cable. * If using a wireless or Bluetooth connection, reset the wireless device settings. * Verify that the correct printer port is selected in the Windows driver. * Clean the printhead. * Ensure the printhead's harness connector is properly connected. * Check your program for a PRINT command at the end of the file and CRLF at the end of each command line.
Why is the left side printout position incorrect on my TSC Printer?
If the left side printout position is incorrect on your TSC Printer: * Set the correct label size. * Fine-tune the Shift X parameter by pressing [MENU] [SELECT] x 3 [DOWN] x 5 [SELECT].
Why is my TSC Printer printing irregularly?
If your TSC Printer is printing irregularly: * Turn the printer off and on to skip the dump mode. * Reset the RS-232 setting.
Why is my TSC Printer printing a gray line on blank labels?
If your TSC Printer is printing a gray line on blank labels, clean the print head and the platen roller.
How do I stop my TSC Printer from skewing labels?
To stabilize label feeding and prevent skewing on your TSC Printer: * If the label is moving to the right, move the label guide to the left. * If the label is moving to the left, move the label guide to the right.
Why is the printing position incorrect on small labels with my TSC Printer?
If the printing position is incorrect for small labels on your TSC Printer: * Recalibrate the sensor sensitivity. * Set the correct label size and gap size. * Fine-tune the Shift Y parameter by pressing [MENU] [SELECT] x3 [DOWN]x6 [SELECT]. * If using BarTender software, set the vertical offset in the driver.
Why is my TSC Printer cutting off print on the sides of the label?
If your TSC Printer is missing printing on the left or right side of the label, ensure the correct label size is set.
What to do if my TSC Printer shows 'No Ribbon'?
If your TSC Printer displays a 'No Ribbon' message: * Supply a new ribbon roll. * Reinstall the ribbon according to the user's manual.
General| Print Speed | 4 ips / 6 ips |
|---|---|
| Memory | 512 MB Flash, 512 MB SDRAM |
| Interface | USB 2.0, Serial, Ethernet |
| Type | Industrial Printer |
| Print Method | Thermal Transfer / Direct Thermal |
| Print Resolution | 203 dpi |
| Communication Interface | USB 2.0, Serial, Ethernet |
| Label Thickness | 0.003" (0.076 mm) ~ 0.012" (0.305 mm) |
| Power Supply | 100 - 240 VAC, 50/60 Hz |
| Operating Temperature | 5 ~ 40°C (41 ~ 104°F) |
| Storage Temperature | -40 ~ 60°C (-40 ~ 140°F) |
| Resolution | 203 dpi |
| Operating Humidity | 20 - 85% RH (non-condensing) |
To Next Page
