TSC TTP-384M - Mechanism and Component Replacement; Removing Printer Covers

11
11
TTP-384M
Bar Code Printer Service Manual
3. MECHANISM
3.1 Remove Covers
1. Remove 4 screws from printer.
2. Open printer right side cover and remove 2 screws then close the cover.
3. Remove the electronics cover.
4. Remove 3 screws from each hinge. Be careful the right side cover may fall out from the
printer. Take out the right side cover from the printer.
Screws
Screws
Screws
Electronics
cover
Right side cover