TSI Incorporated Certifier FA Plus - Factory Calibration (Recommended Yearly); Return Procedure

42 Certifier
®
FA Plus Test System
4.4 Factory Calibration (recommended yearly)
Certifier
®
FA Test System flow modules are designed for one year of normal use
following each factory calibration.
If the test system has been dropped or liquid has penetrated any of its components, do
not use, and return to the factory for calibration.
Recalibrated flow modules come with a certificate of calibration and a summary of
performance before and after the calibration. A factory calibration consists of pressure
transducer calibration over the full range of pressures and calibration over the full range
of flows. All calibration datum are stored in the flow modules, so the Interface Module
does not require calibration. Therefore, it is not necessary to return the Interface
Module for factory calibration.
Follow the steps in Section 4.5 to return Certifier
®
FA Test System flow modules for
factory calibration.
4.5 Return Procedure
Follow these steps to return Certifier
®
FA Test System flow modules for factory
calibration:
1. Obtain a Return Material Authorization (RMA) number using our online RMA form at
rma.tsi.com or contact one of the following offices to make service arrangements.
2. Package the flow modules carefully to avoid damage during shipping.
NOTE: It is not necessary to return the Interface Module for factory calibration.
U.S. & International United Kingdom
TSI Incorporated TSI Instruments Ltd.
500 Cardigan Road Tel: (44) 1494 459200
Shoreview MN 55126-3996 Fax: (44) 1494 459700
USA E-mail: tsiuk@tsi.com
Tel: (800) 874-2811 / Website: www.tsiinc.co.uk
+1(651) 490-2811
Fax: +1(651) 490-3824 Germany
E-mail: technical.service@tsi.com TSI GmbH
Website: www.tsi.com Tel: +49 241-52303-0
Fax: +49 241-52303-49
E-mail: tsigmbh@tsi.com
Website: www.tsiinc.de