8 Part Two
Software Programming
Programming the PresSura Model RPC30 controller is quick and easy if the proper keystroke
procedure is followed. The programming keys are defined first, followed by the required keystroke
procedure. At the end of this section is a programming example.
NOTE: It is important to note that the unit is always operating when programming. When a menu
item value is changed, the new value takes effect immediately after saving the change,
not when the unit returns to normal operating mode.
This section covers programming the instrument through the keypad and display. If
programming through network communications (see Appendix B), use the host
computer’s procedure. The changes take place immediately upon saving data in the
instrument.
Changing Room Mode
1. Press the Room Mode button for the room on the touchscreen.
Figure 5. Main Running Screen
2. Select the desired room mode by pressing on the desired room mode button at the bottom of
the screen.
NOTE: If a room mode is not selected, the PresSura controller will return to the main running
screen after a short delay,
Figure 6. Room Mode Selection Screen
To Next Page
Loading...
