Operating QUESTempº 34 & 36
Print
Flow: On, Off .
Index: none, ACGIH, Navy, EPRI and select either: WBGTi (indoor), WBGTo
(outdoor) for Index setting.
These index settings only apply to the ACGIH Index.
EPRI and Navy will ignore this setting.
Parameters are set from 0 - 9.9C. This is a clothing
correction for the WBGT in degrees Celsius and is
applied to the selected WBGT when the work duration
is calculated. (It will not affect the WBGT as displayed
by the unit.) This value should typically be set to 0.0 for
the Navy. (The field is noted as “Clo Corr”.)
3. Press the I/O Enter key to change a parameter. Time and date require using the Up/Down
Arrows and I/O Enter keys to modify each number.
NOTE: At any time, you can move back one level, by pressing the Run/Stop key.
4. Exit Setup by pressing the Run/Stop key.
Print
QTº34/36 allows printing to a parallel or serial printer or to a computer. The QUESTempº 36 will
recognize the cable plugged in and configure itself for serial or parallel. If no cable is plugged in,
it will default to serial. Press I/O Enter key to begin printing. Press Run/Stop key to return to
the menu.
NOTE: If you want to stop the printing, press I/O enter key until you return to the main menu.
When the printer has stopped printing, remove the cable from the printer to the
instrument.
Reset
Resetting enables you to clear the logged data from memory. Press the I/O Enter key to enter
the Reset mode. Clear the memory by holding down the I/O Enter key while the display counts
down from three.
To Next Page
Loading...
General