30 Appendix D: Detection Management Software DMS
DMS Quick overview
Appendix D: Detection Management Software DMS
The QUESTemp 34/36 Heat Stress Monitor has the flexibility to communicate, download data, create
reports, and save customized setups using the TSI Detection Management Software DMS.
DMS Quick overview
The focus of this section is to briefly explain how to download, create quick reports, and a quick
overview of setup parameters. (Refer to the DMS User Manual for further instructions.)
Downloading your sessions in DMS
Once the QUESTemp⁰ 34/36 is communicating and run/stops are stored on the instrument, this data
may be downloaded into DMS for further analysis and reporting.
Downloading your sessions
1. Download the DMS software. (NOTE: You may have purchased this with your instrument.)
2. Using a TSI cable, part number 054-715, plug the cable into the computer and plug the
opposite end into the side jack of the QT⁰34/36 data port.
Figure 1-24: Communicating to DMS
QT⁰ 34/36 data port
Connected and powered on
To Next Page
Loading...