43
Remote Shutdown
The Failover is completed but the communications and actions have not responded correctly according to
the Failover process, so the Primary unit has been Shut down by the Backup to ensure the Primary has
relinquished the VIPs and communications have been closed before the Backup becomes Active.
Error and Remote Shutdown Resolution
If an error state is displayed or a system controller has been remotely shutdown then the resolution is to
restart the system controller. A unit in error state or that has been remotely shutdown can be restarted
from either the TMRP or the TM1-Mk3+ front panel.
The TMRP will show the error state of the system controller. The key will illuminate red to show there is
an issue, the display will alternately show the state of the system controller and ask if you would like to
restart the device.
To Next Page
Loading...
