Need help?Do you have a question about the TTL Touch and is the answer not in the manual?
General| Brand | TTL |
|---|---|
| Model | Touch |
| Category | Control Panel |
| Language | English |
Specifications for the control and automation panel, covering electrical, dimensions, and conformity.
Technical specifications for the internal connecting board (PCB), including connections and interfaces.
Details on operating modes like OFF, MANUAL/HAND, and AUTOMATIC without external controllers.
Describes operation using activated controllers for temperature and air volume, emphasizing energy saving.
Special functions for energy-saving operation, including temperature setback and SUMMER/WINTER modes.
Manual or BMS-controlled switching between heating (WINTER) and non-heating (SUMMER) operation.
Illustrations and explanations of the control panel's operating elements and menu structure.
Explanation of various symbols used on the touch panel for indicating conditions and status.
Displays showing current air volume performance in OFF, HAND, and AUTOMATIC modes.
Details on how to navigate the main menu and view specific menu items like info, inputs, outputs, and IR sensor data.
Information on malfunctions, inputs (measured values), outputs (control data), and IR sensor readings.
Statistics on motor operation, malfunctions, and device operational values like running time and filter status.
Configuration options for signal assignment, DDC release, automatic contact, room thermostat, and fault dealing.
Settings for AIR controller, including water target standby, blow-out temperature, and PID parameters (P, I, D).
Settings for VOL controller, including winter/summer temperatures, enable, summer/winter switchover, and PID parameters.
Adjusting sensor values for room, outdoor, and IR sensors for accurate controller calibration.
Settings for clock, date, and weekly timer programs for automatic mode operation.
Configuration options for time-based key lock, code lock, and level lock to restrict access.
Setting the time-out duration for the menu to automatically return to the operation view.
System settings for factory default reset, firmware updates, language selection, and parameter loading/writing.
Detailed description of the internal connecting board (ECP-T) and its terminals for various connections.
Information on connecting the control panel via CAN bus and external sensors.
How BMS enable signals affect system start-up and HAND mode activation.
Procedures for restarting the air curtain unit after power interruption or faults.
Table detailing fault numbers, requirements, actions, reset procedures, and display messages for malfunctions.
Troubleshooting guide for common malfunctions like unit not switching on or low air volume.
Instructions on how to perform a system reset via the PCB button or power interruption.
To Next Page