EasyManuals Logo
Home>TurboChef>Oven>2020

TurboChef 2020 Owner's Manual

TurboChef 2020
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
17
TROUBLESHOOTING
Issue Possible Cause(s) Resolution
No power to oven. - Oven is not plugged in.
- Main circuit breaker is
tripped.
- Plug oven in.
- Verify wall circuit breaker is on. Reset breaker
and then power oven back on.
Oven is not warm-
ing up properly.
- Oven is in the off state.
- Oven has been switched off at
the main circuit breaker.
- Oven display is in Celsius
- Problem with the heater.
- Select a cooking profile.
- Press the back/off key until the oven is in the
off state – leave for two minutes. Unplug the
oven – leave for two minutes. Re-plug in the
oven, switch on the isolator/main power supply
and select a cooking profile.
- Change back to Fahrenheit (page 15).
- Call customer service.
Oven is not cook-
ing properly
- Oven is not clean.
- Cook settings were changed.
- Incorrect cooking profile or
belt speed was selected for the
product.
- Product was not cooked from
correct starting state, e.g.
chilled, frozen, etc.
- Clean the oven following the weekly cleaning
instructions on pages 6-8.
- Confirm correct settings (page 12 and 13).
- Ensure that the correct cooking profile is
selected for the product.
- Ensure product is in the correct state before
being placed in the oven.
F1: Blower Failure - Oven power interrupted. - Verify wall circuit breaker is on. Reset breaker
and then power the oven back on. Press the
back/off key until the oven is in the off mode –
leave for two minutes. Unplug the oven – leave
for two minutes. Re-plug in the oven, switch
on the isolator/main power supply and select a
cooking profile.
Troubleshooting
The following is a list of fault codes and error messages, along with the possible problem(s) that the oven
may experience. Please attempt the recommended action before calling Customer Support (800.90TURBO,
+1 214.379.6000) or your Authorized Distributor.
If any fault or error message occurs that is not listed below, contact Customer Support (800.90TURBO,
+1 214.379.6000).
WARNING: Food and oven cavity are hot! Use extreme caution when troubleshooting the
issues below.

Other manuals for TurboChef 2020

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TurboChef 2020 and is the answer not in the manual?

TurboChef 2020 Specifications

General IconGeneral
BrandTurboChef
Model2020
CategoryOven
LanguageEnglish

Related product manuals