TurboChef ChefComm Pro - Setting up a Black Box

Setting Up a Black Box
1. Connect the black box to your computer via
9-pin RS-232 connector cable. See Figure 2
for port location on box.
2. Set the front switch (Figure 2) to PC.
3. Open the battery compartment and verify the
read/write switch (Figure 3) is set to Oven.
4. Insert a smart card as shown in Figure 4.
NOTE: Whenever importing/exporting a menu to and
from ChefComm via RS-232 (see page 11 for more
details), press and hold the synchronization button
(Figure 2) until ChefComm confirms that the
import/export was successful.
2 SETUP
RS-232 Port
Synchronization
Button
OVEN/PC
Switch
Read/Write Switch
Figure 4: Insert Card Chip-First, with Chip Facing Down
Figure 3: Read/Write Switch (Battery Removed for Clarity)
Figure 2: Black Box Front