EasyManua.ls Logo

TurboChef Eco - CLEANING; Oven Interior, Door, and Component Cleaning; Reinstallation and Exterior Cleaning Steps

TurboChef Eco
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
CLEANING
Step 6
Step 6: Clean the Oven Interior, Continued
Allow Oven Cleaner to penetrate stains for five minutes.
Clean the oven interior with a nylon scrub pad.
!
CAUTION: DO NOT attempt to scrub the upper jetplate (A). If food is stuck to the
oven ceiling, gently remove it without applying pressure to the AFC plate. Breakage will
result in a non-warranty service call.
!
CAUTION: DO NOT remove the top AFC jetplate (A); breakage will result in a
non-warranty service call.
Step 7: Clean and Dry the Oven Door
Clean the oven door with Oven Cleaner and a nylon scrub pad.
Wipe the oven door with a damp towel, and then a dry towel.
Step 8: Rinse or Wipe the Oven Interior
!
CAUTION: DO NOT use a hose or water jet for cleaning. Doing so can damage critical
oven components, resulting in a non-warranty service call.
Wipe down the oven interior with a clean damp towel.
Remove the lower tray and remove large food particles.
Wipe the tray with a clean, damp towel.
Dry the oven interior with a clean towel.
Step 9: Apply TurboChef Oven Guard
Spray TurboChef Oven Guard onto a clean towel.
Wipe the interior walls and the inside of the oven door.
!
CAUTION: DO NOT spray Oven Guard into the cavity, especially around the holes
on the back oven wall. Doing so can damage critical oven components, resulting in a
non-warranty service call.
Step 10: Reinstall Components
Reinstall the lower jetplate and tighten the thumbscrew.
Reinstall the wire rack.
Close the oven door.
Reinstall the filter, or replace it with a new one if the mesh is deteriorated, has
large openings, or has started to dislodge from the frame.
Step 11: Clean the Oven Exterior
Wipe the oven exterior with a clean, damp towel.
!
CAUTION: DO NOT spray chemicals into any openings, such as the louvers
on the side panels or the rear vent catalyst housing. Doing so can damage
critical oven components, resulting in a non-warranty service call.
The oven is ready to turn on.
Step 7
Step 8
Step 9
Step 10
Step 11
A
ECO-1001 / Revision G / August 2023ECO-1001 / Revision G / August 2023

Table of Contents

Other manuals for TurboChef Eco

Related product manuals