20
LEGACY CONTROLLER OPERATION
Step 3: Warming Up
NOTE: When the oven is done warming up, it will “soak” for an
additional eight minutes. “Soaking” ensures the cavity surfaces absorb
enough heat so that cooking will not be affected.
Step 2: Select Cook Temperature
NOTE: If the temperatures are the same, or if Manual Mode is
disabled, this screen will be bypassed.
Step 1: Touch “Menu” or the Oven Set Temperature Icon to Turn the Oven On
Menu Cook Mode: Legacy Controller
The oven is preprogrammed with recipe settings at the time of manufacture and is ready to operate out of the
box. New menu settings can be loaded via USB (page 28) or programmed manually (page 30).
If settings are not present, the oven will cook only in manual mode (page 23).
This oven uses impingement and microwave to cook food faster than traditional cooking methods. Air enters
the cavity from the top and bottom using a single fan. Because of this design and to ensure uniformity of
cooking, the oven must be operated only while the bottom jetplate is in place. While the bottom jetplate is
removable for cleaning, it is not removable for cooking. Without the bottom jetplate in place, the oven will
not deliver the proper cooking performance to either the top or bottom of the food item. Additionally, oven
damage may result.
The sequence of the steps below may vary, and some may not apply.
Figure 37: Power On
Figure 38: Temperature Selection
Figure 39: Warming Up
ECO-1001 / Revision G / August 2023
To Next Page
Loading...
