28
LEGACY CONTROLLER OPERATION
2. Toggle the yes/no icon to the YES position to
enable Auto On.
3. Select the temperature to which the oven will
automatically heat up.
4. Enter the time in 24-hour format (8:30 p.m. =
20:30). Touch “SAVE” to save all changes.
NOTE: The time will automatically convert to
12-hour format when saved.
Auto Off
“Auto Off ” is a feature that turns the oven off
automatically at a specific time of day.
1. To set auto-off time, ensure the time of day is
accurate (page 28).
2. Toggle the yes/no icon to the YES position to
enable Auto Off.
3. Enter the time in 24-hour format (8:30 p.m. =
20:30). Touch “SAVE” to save all changes.
NOTE: The time will automatically convert to
12-hour format when saved.
Info Mode: Service Screen
Only qualified service technicians should access
the service options, unless otherwise instructed by
TurboChef.
Info Mode: Manufacturing (MFG)
Only qualified service technicians should access
the MFG options, unless otherwise instructed by
TurboChef.
!
CAUTION: Changing the oven model will
result in the oven not cooking properly and a
non-warranty service call.
Load Menu from USB
NOTE: To update a menu, you may need to verify
that access to the Load Menu screen is turned on.
See page 25 for details.
USB setup: When loading from USB, the menu
must be in BIN (binary) format. The files must
be loaded on the root of the USB. To obtain the
proper binary file, contact your menu administrator,
TurboChef Technical Support, or consult your
ChefComm OneTouch® instructions.
To load a menu to the oven,
1. When the oven is off or cooling down, insert the
USB (see next page). The oven will automatically
detect the device. Touch “OK” to proceed.
2. Load the menu:
a. Touch “Load Menu to Oven.”
b. Touch “OK” to confirm the selection and
begin the installation.
c. Touch the menu to load.
NOTE: If multiple menus are on the USB, the
oven will display the menu names. Otherwise this
step will be bypassed.
ECO-1001 / Revision G / August 2023
To Next Page
Loading...
